The Toyota Supra Community for all Supra generations

Owners of the fifth generation Toyota Supra are thrilled about that car

In July 1993, the fourth and so far last generation of the Supra came on the market. Internationally, this type is called " Supra MKIV ".

In early 1986, the third generation of the Supra was introduced. It is also the first that has not been marketed with the suffix Celica.

The second generation was presented in the fall of 1981 and had a completely independent drive with the new (170 hp) 6-cylinder engines.

The first Supra built from spring 1978 to summer 1981 was still offered as a top version of the Celica first in Japan and later in the United States.

Oil and filter replacement - Lubrication - Toyota Supra A80

Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
In order to preserve the environment, used oil and used oil filters must be disposed of only at designated disposal sites.

Drain engine oil
1. Remove the oil filler cap.
2. Remove the oil drain plug, and drain the oil into a container.
Replace oil filter
1. Using SST, remove the oil filter.
  SST 09228-07501
2. Check and clean the oil filter installation surface.
3. Apply clean engine oil to the gasket of a new oil filter.
4. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
5. Using SST, tighten it an additional 3/4 turn.
  SST 09228-07501

Refill with engine oil

To wipe off oil that has dripped onto the engine under cover, remove the 4 screws and bend the under cover downward.
- To avoid damaging the silencer, do not bend the engine under cover more than 150 mm (5.91 in.).
- If oil gets on the silencer, wipe it off with a dry rag.
Clean and install the oil drain plug with a new gasket.
Torque: 38 N·m (375 kgf·cm, 27 ft·lbf)

Fill with fresh engine oil.

This guide is based on the book edition Toyota (RM502U, 1997)