Supra generations

Kaufe und verkaufe gebrauchte oder neue Teile kostenlos auf SUPRA.PARTS

Toyota Classics

Photos, videos and informations about the Toyota 2000GT & Celica XX Supra

Toyota 2000GT & Celica Supra

The first Supra built from spring 1978 to summer 1981 was still offered as a top version of the Celica first in Japan and later in the United States.

MK 2

Photos, Videos, Infos and more for the Toyota Supra MK2

Celica Supra MKII (MA 60/61)

The second generation was presented in the fall of 1981 and had a completely independent drive with the new (170 hp) 6-cylinder engines.

MK 3

Photos, Videos, Infos and more for the Toyota Supra MK3s

Toyota Supra MKIII (MA70/MA71)

The second generation was presented in the fall of 1981 and had a completely independent drive with the new (170 hp) 6-cylinder engines.

MK 4

Photos, Videos, Infos and more for the Toyota Supra MKIV

Toyota Supra MKIV (A80)

In July 1993, the fourth and so far last generation of the Supra came on the market. Internationally, this type is called " Supra MKIV ".

MK 5

Photos, videos, informations and more about the new Toyota Supra

Toyota Supra MKV (A90)

Owners of the fifth generation Toyota Supra are thrilled about that car
Modelle: ClassicsMK2MK3MK4MK5
Repair Manual

2JZ-GE engine - Diagnostics - Toyota Supra A80

with love by
Donate their awesome work


How to proceed with troubleshooting

Troubleshoot in accordance with the procedure on the following page.

Titles inside        are titles of pages in this manual, with the page number indicated in the bottom portion. See the indicated pages for detailes explanations.

Vehicle Brought to Workshop
⇓
Customer Problem Analysis P. DI-2
⇓
Connect the OBD II scan tool or TOYOTA hand-held tester to DLC3 P. DI-3
If the display indicates a communication fault in the tool, inspect DLC3 P. DI-3
⇓
Check DTC and Freezed Frame Data (Precheck)
Record or Print DTC and Freezed Frame Data P. DI-3
⇓
Clear DTC and Freezed Frame Data P. DI-3
⇓
Visual Inspection
⇓
Setting the Check Mode Diagnosis P. DI-3
⇓
Problem Symptom Confirmation
If the engine does not start, perform steps 10 and 12 first
Malfunction occurs. ║ ⇓ Malfunction does not occur.
║
Symptom Simulation P. IN-18
⇓ ⇓
DTC Check P. DI-3
Normal ⇓ ⇓ Malfunction code.
Basic Inspection P. DI-3
DTC Chart P. DI-14
║ ⇓ ║
║
Matrix Chart of Problem Symptom Table P. DI-24
║
⇓ ⇓ ⇓ ⇓
Parts Inspection
Circuit Inspection P. DI-25
║ ⇓ ║
║
Check for Intermittent Problems P. DI-3
║
⇓ ⇓ ⇓
Identification of Problem
⇓
Adjustment, Repair
⇓
Confirmation Test
⇓
End

Customer problem analysis check

This guide is based on the book edition Toyota (RM502U, 1997)
Oxwall Community Software